106 Configuring a 2370, 2360, or 2380 Switch for Basic Service
To verify the configuration changes, use the following commands. Use show ap config for directly connected
APs and use show dap config for Distributed APs. (See
page 114
for an example.)
show ap config [port-list [radio {1 | 2}]]
show dap config [dap-num [radio {1 | 2}]]
The following example sets ports 1, 2, and 4 for AP access point model 2330:
2370# set port type ap 1,2,4 model 2330 poe enable
This may affect the power applied on the configured ports. Would you like
to continue? (y/n) [n]y
success: change accepted.
To verify the configuration change, use the following command:
show ap config [port-list [radio {1 | 2}]]
Here is an example:
2370# show ap config 1
Port 1: AP model: 2330, POE: enable, bias: high, name: MP01
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 15, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
Configuring for a Distributed AP
To create a configuration for a Distributed AP (referred to as a DAP in the CLI), use the following command:
set dap dap-num serial-id serial-ID
model {AP2750 | mp-52 | mp-101 | mp-122 | mp-241 | mp-252 | mp-262
| mp-341 | mp-352 | 2330}
[radiotype {11a | 11b| 11g}]
The dap-num parameter identifies the Distributed AP connection for the AP. The range of valid connection ID
numbers depends on the WSS model:
•
For a 2380, you can specify a number from 1 to 300.
•
For a 2370, you can specify a number from 1 to 100.
•
For a 2360, you can specify a number from 1 to 30.
For the serial-id parameter, specify the serial ID of the AP. The serial ID is listed on the AP case. To display
the serial ID using the CLI, use the show version details command.
320656-A
"Displaying Radio Configuration Information" on