Nortel 2350 Installation And Basic Configuration Manual page 149

CA certificate
2370# copy tftp://10.10.20.24/eap.pem
success: received 637 bytes in 0.253 seconds [ 2517 bytes/sec]
2370# crypto otp eap otp2
OTP set
2370# crypto pkcs12 eap eap.pem
Unwrapped from PKCS12 file:
keypair
device certificate
CA certificate
2370# copy tftp://10.10.20.24/webaaa.pem
success: received 637 bytes in 0.253 seconds [ 2517 bytes/sec]
2370# crypto otp webaaa otp3
OTP set
2370# crypto pkcs12 webaaa webaaa.pem
Unwrapped from PKCS12 file:
keypair
device certificate
CA certificate
Note.
After you generate or install a certificate, do not create the key pair again.
If you do, the certificate might not work with the new key, in which case you will
need to regenerate or reinstall the certificate.
9
Set the country code to US:
2370# set system countrycode US
success: change accepted.
10 Add the 2350 to the local user VLAN, branch1_vlan. (Because the uplink port is now in two VLANs, the
default VLAN for 2350 management and a user VLAN, the port must be tagged.) Then verify the
changes.
2370# set vlan 2 name branch1_vlan
success: change accepted.
2370# set vlan branch1_vlan port 1 tag 1
success: change accepted.
2370# show vlan
Admin VLAN
VLAN Name
State
---- ---------------- ------ ----- ----- ---------------- -----
-----
1 default
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Configuring a 2350 Switch for a Branch Office 149
Tunl
Status State Affin Port
Up
Port
Up 5
Tag