Figure 17. GBIC Removal from 2370 Switch
To install a GBIC:
1
Insert the GBIC into a GBIC slot on the front panel until it clicks into place.
2
Remove the protective covering(s) from the port connector(s) and set them aside in a safe place for later
use.
3
Insert the network cable.
Note.
cable ends in the proper sides (transmit or receive). Otherwise, the link does not
work.
4
Observe the upper LED to the right of the GBIC port:
●
If the LED is green, the 1000-Mbps link is operational.
●
If the LED is blinking amber, traffic is active on the 1000-Mbps link.
●
If the LED is unlit, the link is not operational. Check the cable and verify that the device at the other
end of the link is operational.
To remove a GBIC:
1
Remove the network cable(s).
2
Insert the protective covering(s) into the port connector(s).
3
Squeeze the clips on the sides of the GBIC and pull the GBIC out of the slot.
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Installing and Connecting a WLAN—Security Switch 55
For 1000BASE-SX or 1000BASE-LX fiber, make sure you insert the two
Squeeze the
lock clips to
release GBIC.