Nortel 2350 Installation And Basic Configuration Manual page 111

• Encrypted SSID—Clients using this SSID must use encryption. Use the encrypted SSID for secured access to your
enterprise network.
• Clear SSID—Clients using this SSID do not use encryption. Use the clear SSID for public access to nonsecure
portions of your network.
A radio can send and receive traffic for both types of SSID at the same time. By default, a radio sends beacons to
advertise the encrypted SSID but does not advertise the clear SSID.
To configure and display a radio profile, use the following commands:
set radio-profile name
show radio-profile name
Note.
Nortel recommends that you do not use the name default. WSS Software already
contains a radio profile named default. (For information about the default radio profile, see
the Nortel 2300 Series System Software Configuration Guide.)
The following command configures radio profile rp1:
2370# set radio-profile rp1
success: change accepted.
Table 10 lists the radio profile parameters and their default values. For information about these parameters and how to
change them, see the Nortel Mobility System Software Configuration Guide.
Parameter
11g-only
active-scan
beacon-interval
countermeasures
dtim-interval
frag-threshold
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Configuring a 2370, 2360, or 2380 Switch for Basic Service 111
Table 10.Defaults for Radio Profile Parameters
Default
Value
disable
enable
100
Not configured
1
2346
Radio Behavior When
Parameter Set To Default
Value
Allows associations with 802.11g and
802.11b clients.
Note: This parameter applies only to
802.11b/g radios.
Sends probe any requests (probe
requests with a null SSID name) to
solicit probe responses from other
access points.
Waits 100 ms between beacons.
Does not issue countermeasures against
any device.
Sends the delivery traffic indication
map (DTIM) after every beacon.
Transmits frames up to 2346 bytes long
without fragmentation.