Nortel 2350 Installation And Basic Configuration Manual page 113

• External antenna model—internal antenna used by default (except the MP-262, which uses ANT1060 by
default)
Note.
The channel and power defaults listed above apply only when Auto-RF is
disabled. Auto-RF can automatically set and adjust the channel and power settings on
radios. By default, Auto-RF for channel assignment is enabled, and Auto-RF for power
setting is disabled.
You are not required to set any of these radio-specific parameters (except the external antenna type, if different
from the default). Auto-RF sets the channels automatically to avoid channel interference, and the default
power levels are high enough for most installations.
If you do need to set the channels or power manually, use the following commands:
set {ap port-list | dap dap-num} radio {1 | 2} channel channel-number
set {ap port-list | dap dap-num} radio {1 | 2} tx-power power-level
To change the external antenna type, use the following command:
set {ap port-list | dap dap-num} radio
{1 antennatype ANT1060 | ANT1120 | ANT1180 | internal} |
{2 antennatype ANT5060 | ANT5120 | ANT5180 | internal}
The following command configures radio 1 (the 802.11b/g radio) on Distributed AP 1 to use external antenna
model ANT1060:
2370# set dap 1 radio 1 antennatype ANT1060
success: change accepted.
To enable or disable Auto-RF for channel or power assignment, use the following commands:
set radio-profile name auto-tune channel-config {enable | disable}
set radio-profile name auto-tune power-config {enable | disable}
Applying a Radio Profile to Radios and Enabling the Radios
To apply a radio profile to radios, use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} radio-profile name
mode {enable | disable}
The following commands applies radio profile rp1 to radio 1 on AP access ports 1, 2, and 4 and on Distributed
AP 1 and Distributed AP 2 and enables the radios:
2370# set ap 1,2,4 radio 1 radio-profile rp1 mode enable
success: change accepted.
2370# set dap 1,2 radio 1 radio-profile rp1 mode enable
success: change accepted.
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Configuring a 2370, 2360, or 2380 Switch for Basic Service 113