Removing the NE1032T from a Standard Equipment Rack
1. Disconnect all external cables.
2.
If the air‐duct option has been installed, remove it as described in "Removing the
Air‐Duct Option" on page
3. Loosen and remove M6 screws, washers, and clip nuts (or cage nuts) to release the
switch unit from the rack.
© Copyright Lenovo 2017
This section describes how to remove the NE1032T from a standard 19‐inch
equipment rack. For information about removing the switch from other supported
racks, see the appropriate section in this chapter.
To remove the NE1032T from a standard rack, complete the following steps:
3
6
74.
4
Chapter 4: Removing and Replacing Components
67