Installing the NE1032T in a Lenovo iDataPlex Rack
Statement 26
© Copyright Lenovo 2017
This section describes how to install the NE1032T in a Lenovo iDataPlex rack. The
iDataPlex mounting kit allows the switch to be mounted either horizontally or
vertically.
The kit must be purchased separately. It includes the following parts:
Table 11.
Lenovo Adjustable 19" 4‐Post Rail Kit parts
Item number
Description
1
Switch front brackets
2
M4 screws
3
M6 screws
4
M6 clip nuts
5
M6 locking washers
6
Switch rear brackets
7
Rear alignment plates
Attention: The rack‐mounting frame may not be able to support the weight of the
networking switch with only the front post mounting brackets (2‐post application).
If the switch has an undesirable amount of sag, it is recommended to use a 4‐post
mounting kit.
Attention: For earthquake stability, mount the switch in a 4‐post rack.
CAUTION:
Do not place any object on top of rack‐mounted devices.
Quantity
2
16
8
8
8
2
2
Chapter 3: Installing NE1032T Hardware and Options
47