Table of Contents
Advertisement
1. Remove the safety cap and pull the locking lever into the down (unlocked)
2. Insert the transceiver into the slot until it clicks into place. Use minimal pressure
3. Pull up the locking lever to lock the transceiver into place.
4.
56
NE1032T Installation Guide
To install an SFP optical transceiver in an SFP+ port slot on the switch, complete the
following steps.
Note: To avoid damage to the cable or the SFP transceiver, do not connect the cable
before you install the transceiver.
position.
when you insert the transceiver. Do not use excessive force when you insert the
transceiver or you might damage the transceiver or the slot.
The transceiver has a mechanical guide key to prevent you from inserting the
transceiver in an incorrect orientation.
Connect the fiber‐optic cable following the "Cabling Guidelines" on page
To remove an SFP optical transceiver, disconnect the fiber‐optic cable, and pull
down the locking lever to release the transceiver. After you remove the transceiver,
replace the safety cap.
39.
Hide quick links:
Advertisement
Table of Contents
