Installing the Air-Duct Option
50
NE1032T Installation Guide
The NE1032T supports an optional 1U air duct to maximize air flow conditions in a
19" rack.
The air‐duct option is only supported when the switch is installed on a 4‐post rack
mount kit basis. If the switch is installed on a rack using default 2‐post rack mount
kit, it will not support the air‐duct option.
For information on removing an installed 1U air‐duct option, see "Removing the
Air‐Duct Option" on page
The following table lists the parts included with the air‐duct option kit.
Table 12.
Air‐duct Option Kit parts
Item Number
Description
1
Cable tie
2
1U Duct sleeve (long)
3
Mounting bracket (left)
4
Mounting bracket (right)
5
Foam carrier assembly
6
M3.5 screws
Attention: The rack‐mounting frame may not be able to support the weight of the
networking switch with only the front post mounting brackets (2‐post application).
If the switch has an undesirable amount of sag, it is recommended to use a 4‐post
mounting kit.
74.
6
5
1
Quantity
4
1
1
1
2
6