Table of Contents
Advertisement
1. Select an empty power supply module bay on the rear of the switch. If the target
2. Insert the power supply module into the selected power‐supply bay and gently
3. Connect the power cord to the power supply module and to an appropriate
4. Make sure that the power supply module's LEDs are green.
64
NE1032T Installation Guide
To replace a hot‐swap power supply module, complete the following steps:
bay is protected by a blank power filler plate, remove the blank.
push it into the slot until it latches. Each power supply module has a mechanical
guide key to prevent you from inserting the module incorrectly.
universal grounded AC power source.
Hide quick links:
Advertisement
Table of Contents
