Lenovo ThinkSystem NE1032T Installation Manual page 76

3. Set the new switch to use the Machine Type‐Model (MTM) number of the old unit.
4. Set the new switch to use the serial number of the old unit. For example:
5. Reset the switch using the following command:
6. When prompted for confirmation, enter y. The switch will then restart.
76
NE1032T Installation Guide
For example:
NE1032T(config)# hardware mtm 1234-56X
New MTM value: 1234-56X
Please reset the system for the new changes to take effect
where 1234-56X is the MTM from your old unit.
Note: The MTM shown here is merely an example. Use the actual MTM recorded
from your old NE1032T unit.
NE1032T(config)# hardware esn XX01234567
where XX01234567 is the serial number of your old unit.
Note: The serial number shown here is merely an example. Use the actual serial
number recorded from your old NE1032T unit.
NE1032T# reload