Removing the NE1032T from a Lenovo System x or Power
Rack
1. Disconnect all external cables.
2.
If the air‐duct option has been installed, remove it as described in "Removing the
Air‐Duct Option" on page
3. Loosen and remove M3.5 screws that secure the rear brackets to the front brackets.
4. Loosen and remove the M6 screws, washers, and clip nuts (or cage nuts) that attach
the filler plate and rear mounting brackets to the rear rack posts.
© Copyright Lenovo 2017
This section describes how to remove the NE1032T from a Lenovo System x or
Power 4‐post rack.
To remove the NE1032T from a System x or Power rack, complete the following
steps:
9
74.
3
10
Chapter 4: Removing and Replacing Components
5
69