Installing The G8124-E In A Lenovo Idataplex Rack - Lenovo G8124-E Installation Manual

Installing the G8124-E in a Lenovo iDataPlex Rack

© Copyright Lenovo 2015
This section describes how to install the G8124-E in a Lenovo iDataPlex rack. The
iDataPlex mounting kit allows the switch to be mounted either horizontally or
vertically.
The kit must be purchased separately. It includes the following parts:
Table 9. Lenovo Adjustable 19" 4-Post Rail Kit parts
Item number Description
Switch front brackets
1
M4 screws
2
M6 screws
3
M6 clip nuts
4
M6 locking washers
5
Switch rear brackets
6
Rear alignment plates
7
Attention: The rack-mounting frame may not be able to support the weight of the
networking switch with only the front post mounting brackets (2-post application). If
the switch has an undesirable amount of sag, it is recommended to use a 4-post
mounting kit.
Attention: For earthquake stability, mount the switch in a 4-post rack.
Statement 26
CAUTION:
Do not place any object on top of rack-mounted devices.
To install the G8124-E in an iDataPlex rack, complete the following steps:
1. Locate, record, and retain the product switch information in order to configure
and register your product. See
page 28.
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch
and affix the new label to the bottom of the new switch.
Quantity
"Recording Important Product Information" on
Chapter 3: Installing G8124-E Hardware and Options
2
16
8
8
8
2
2
39