Faults with water intake or drainage
Problem
The In-operation
indicator is flashing
quickly. The buzzer is
sounding. One of the
following faults appears
in the display:
Open stopcock
Inlet
Drain
Cause and remedy
The stopcock is closed.
Open the stopcock fully.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water intake is restricted.
Open the stopcock fully.
Check the water inlet filter and clean it if necessary
(see "Maintenance").
The water pressure at the intake is lower than
30 kPa (0.3 bar).
Seek professional advice.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water outlet is restricted.
There might be water in the wash cabinet.
Clean the filter combination (see "Cleaning and
care").
Clean the drain pump (see "Maintenance").
Clean the non-return valve (see "Maintenance").
Remove any kink or loop in the drain hose.
Problem solving guide
51