Add Salt Reminder; Rinse Aid - Miele PG 8083 SCVi Operating Instructions Manual

Add salt reminder

 When 
Add salt
display wait until the end of the
programme and then refill the salt
reservoir.
 Press the middle button to confirm.
The refill reminder will go out.
After the salt reservoir has been filled,
the refill reminder may still appear in the
display if the salt concentration has not
yet reached the correct level. If this is
the case, confirm again with the middle
button.
The salt refill reminder is deactivated if
the dishwasher is set to a water
hardness of less than 0.7 mmol/l (0 - 4
°dH).

Run the "Pre-wash" or the
"Short" programme immediately
without a load in order to remove any
traces of salt from the cabinet.
appears in the
Commissioning

Rinse aid

Rinse aid is necessary to ensure water
does not cling and leave marks on
crockery during the drying phase, and
helps crockery dry faster after it has
been washed.
Rinse aid is poured into the storage
reservoir and the amount set is
dispensed automatically.

Fill the reservoir with rinse aid
only. Do not fill it with washing-up
liquid or cleaning agent.
This would damage the rinse aid
reservoir.
Suitable products are available from
Miele Professional.
Alternatively household vinegar with a
max. 5 % acid content or liquid citric
acid with a max. 10 % acid content can
be used. The resulting rinsing and
drying quality will not, however, be as
good as when rinse aid is used.

Do not use vinegar with a higher
acid content (e.g. vinegar essence
25 % acid).
This would damage the dishwasher.
23