Problem solving guide
Faults with water intake or drainage
Problem
One of the following
fault messages appears
in the display:
Open stopcock
Water intake
The following fault mes-
sage appears in the dis-
play:
Drain
62
Cause and remedy
The stopcock is closed.
Open the stopcock fully.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water intake is restricted.
Open the stopcock fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than
30 kPa (0.3 bar).
Seek professional advice.
Before rectifying the problem:
Switch the dishwasher off with the button.
Water drainage fault.
There might be water in the wash cabinet.
Clean the filter combination (see "Cleaning and
care, Cleaning the filters").
Clean the drain pump (see "Maintenance").
Clean the non-return valve (see "Maintenance").
Remove any kink or loop in the drain hose.