Detergent Amount; Venting Dos - Miele PG 8083 SCVi Operating Instructions Manual

Detergent amount

This function only becomes visible
when External DOS is activated.
When using liquid dispensing via an
external dispensing module, you can
dispense cleaning agent according to
the detergent manufacturer's
instructions in millilitres or as a
percentage.
– Amount in ml
30 ml is set as standard. The
dispensed quantity can be modified
between 10 and 100 ml in 2 ml steps.
– Amount as %
0.50 % is set as standard. The
dispensed quantity can be modified
between 0.17 and 1.67 % in 0.03 -
0.04 % steps.
Setting the dosage:
Set the dosage according to the
cleaning agent manufacturer's
recommendations.
The dishwasher uses approx. 6.5 l of
water for the main wash cycle.
Example:
The cleaning agent manufacturer
recommends 4 ml (or 0.07 %) of
cleaning agent per litre of water.
6.5 l x 4 ml/l = 26 ml.
(6.5 l x 0.07 %/l = 0.455 %)
 Select the desired amount of cleaning
agent or dosage concentration and
press the middle button to confirm.

Venting DOS

The DOS system will not dispense
reliably if there is air in the system.
The DOS system must be vented:
– if the dispensing system is being
used for the first time,
– if the liquid cleaning agent reservoir
was not refilled in time and the DOS
system was emptied.
– if the cleaning agent container was
replaced.

To ensure that the dispensing
system functions properly, prior to
venting make sure that the cleaning
agent container is full enough and
that the dispensing lances are firmly
attached to the containers.
 Select
Start venting
middle button to confirm.
The venting process will begin. The
remaining time appears in the display.
The "Pre-wash" programme is offered
directly after the venting process is
finished. Start the programme in order
to dilute and drain any cleaning agent
that escaped into the wash cabinet.
Settings menu
and press the
75