Coffee Circuit Cleaning Cycle - LaCimbali Q10 Use And Installation

These procedures are to be performed at the end of the work
day or when the machine sends a message (see paragraph
"Customer programming Services hour menu).
hen the machine sends a message, the screen displays
" S
signal.
The message and signal will continue until the wash cycle is
performed or up until the end of the timeout (60').
Please follow these instructions for the washing process
1) After the machine sends the message;
2) Open the door to access the programming keypad;
Lower the dispensing nozzle (1);
3) Keep the coffee circuit washing key (26)
the message S
below
START WASHING
Press
Keep the coffee circuit washing key pressed again (26)
until the message
S
on the display
10 March 2010
wednesday
WASHING IN PROGRESS
ait until the machine performs an automatic washing
cycle (approximately 2 minutes).
The washing cycle has ended when this message appears
on the display
WASH COMPLETED
MACHINE READY
PRESS ANY KEY
4) Press any dispensing key to return to normal work
operations.
NOTE. Once the wash cycle is underway, it CANNOT be
stopped, even if the machine is switched off.
If the power supply goes off or the machine switches off
during the cycle, when the power returns the message
PRESS WASH" will appear on the display screen.
(Level 1)

COFFEE CIRCUIT CLEANING CYCLE

Level 1
", accompanied by an acoustic
, pressed until
appears, as shown
S
SS appears
15 15 04
1
2
1
3
4
To continue, press key (26)
cycle.
Programmed wash cycles that are not effected will be memo-
rized by the machine.
Selection block - This occurs after 60' of functioning from the
preset time if the washing cycle has not taken place, with the
"Block coffee circuit" function enabled ( ES) by the installer.
60
26
to complete the cleaning