Panasonic KX-TD500 Programming Manual page 349

Error Code
E5006 Cannot assign more than 1000 account codes.
There is a limit of 1000 account codes per system.
E5007 You have exceeded the tenant limit of Speed Dialing numbers.
The maximum number of Speeding Dialling numbers per tenant is specified in
"2-1 Tenant" screen.
E5008 You have exceeded the limit of Caller ID codes.
There is a limit of 1000 Caller ID codes per tenant and 2000 Caller ID codes per
system.
E5009 Invalid User code.
If the entire code, for ex. (1234), is included in another code, for ex. (12345), it is not
valid.
E5010 Specify the code.
The account code also must be entered when the TRS Level is assigned and the TRS
Level also must be deleted when the account code is deleted.
E5011 Specify the leading digits.
The ARS leading dial also must be entered when the Route Plan Table No. is assigned
and the Route Plan Table No. also must be deleted when the leading dial is deleted.
E5020 Charge Verification ID Code format error.
Please assign the Charge Verification ID code of 4 digits consisting of 0-9.
E5021 Don't keep Rate to be Blank.
The value of "Rate" must be always assigned.
E5022 File format error. (Line: X)
Format (syntax) error was found at the indicated line (X) in the database file.
E6001 Too long TRS Deny or Exception dial.
TRS Deny or Exception dial can be registered up to 10 digits consisting of 0–9,
or X (a wild card).
E6002 Cannot assign more than 400 TRS deny codes.
There is a limit of 400 toll restriction deny codes per system.
E6003 Cannot assign more than 200 TRS exception codes.
There is a limit of 200 toll restriction exception codes per system.
E7001 Invalid arrangement of time zones.
Each successive ARS time zone must be later in time. Namely, this pattern must be
followed: Time-A < Time-B < Time-C < Time-D.
E7002 Assign both trunk group number and modification table number.
Cannot assign just trunk group number or just modification table number.
Both must be assigned as a pair under ARS routing plan.
Programming Guide
Error Message
Description
Programming Error Messages
, #
349