Table of Contents
Advertisement
Installing Dräger Polytron 7500
Installing the Dräger Polytron 7500
Unpack the Dräger Polytron 7500.
Remove the cover of the Polytron 7500. To do this
1 gently pull apart the cover on both sides and
2 lift upwards.
Fit the Polytron 7500 using the metal hooks into the slots provided on the docking
station.
Attention! The electrical connection via the edge connector must be clean,
i.e. the safety hooks (3) underneath must snap into the docking station.
Slide cover back over the installed Polytron 7500 until it snaps into place at the
sides.
Attention! No cables or internal hoses must be pinched.
Connecting the hoses:
Insert the hose into the quick release fastener below the unit.
4 Gas input from the inlet point right connection (marked with O-ring).
5 Gas output to the offtake left connection.
Check the hoses to make sure they are inserted properly
Page 12 of 72 Pages
2
1
3
5
4
9023927 - 2nd edition - May 2007
1
Advertisement
Table of Contents
