Table of Contents
Advertisement
Activating info mode
The info mode is used to display information about general unit settings and the
unit status.
Press and hold the »
units is displayed on several screens.
— Briefly press the »
« key to move to the next screen.
— Briefly press the »
« to move back to the previous screen.
M
— The info mode can be terminated at any time by pressing the »
— If no key is pressed for 30 seconds, the unit automatically returns to its
previous state.
Example of info mode:
Screen 1
Instrument information
Line 1 – Date and time
Line 2 – Software version
Line 3 – Unit Part No.
Line 4 – Unit Serial No.
Line 5 – Unit code
Screen2
Sensor information:
Line 1 – Sensor name
Line 2 – Sensor Part No.
Line 3 – Sensor Serial No.
Line 4 – EEPROM type
Line 5 – EEPROM version
Screen. 3
Sensor configuration:
Line 1 – Gas name
Line 2– Measuring range (cannot be change) and unit of measurement
Line 3 – Measuring range for the analogue interface.
displayed only if the analogue interface card is installed
Line 4 – A1 alarm threshold and unit of measurement
Line 5 – A2 alarm threshold and unit of measurement
Screen 4
Pump Infos:
Line 1 – Pump flow
Line 2 – Threshold error
Line 3 – Threshold warning
Line 4 – Pump run time
1)
Displayed only if a relay module is fitted!
9023927 - 2nd edition - May 2007
« key (longer than 3 seconds) – information about the
1)
1)
« key.
OK
07.05.2005
SW Version: 1
Part No.
Serial No. : ARUA0001
DeviceCode : 00006317
Instrument Info
Sensorname: NF3
Part No.
Serial No. : XXXXXXX
EEPROM Typ : 1
EEPROM Vers.: 1
Sensor Info
Gasname
Range
4–20 SP
Alarm A1
Alarm A2
Sensor Config
Power
Fault
Warning :
Op. time :
Pump Info
Start-up
12:34
: 8318827
1/4
: 6811125
2/4
: NF
3
: 30.0 ppm
: 30.0 ppm
: 5.0 ppm
: 10.0 ppm
3/4
:
XXX %
:
X.X l/min
X.X l/min
XXXX h
4/4
Page 19 of 72 Pages
Advertisement
Table of Contents
