Setup Troubleshooting; Symptoms And Actions; If Your Problem Cannot Be Resolved - Contec IPC Series User Manual

2. Setup

Setup Troubleshooting

Symptoms and Actions

PC does not start up after this product has been mounted.
This product does not work.
"!" mark is shown in [Device manager].
Make sure that this product is attached correctly.
Check if there is any shortage of resources allocatable to this product.
When using a board not compliant with Plug and Play, change the resource allocation for the board. If
the resource cannot be changed, use both the board and this product as the situation demands.
The resource may be conflicted to other peripheral devices. Check the settings of the expanded
peripheral device.
Check the boot device order to see if the setting is made so that OS is booted from the device where OS
is installed.
PC operation is unstable.
Change the PCI slot location for mounting this product.
This product is not registered in the disk drive.
The product cannot be registered in the [disk drive] of the [device manager], when installed in the PCI-
to-PCI Bridge environment.
Mirroring (RAID1) cannot be built for the OS startup drive.
When building mirroring in PC-RSD1000/2000/4000-PCI (when only one copy of the attached CF is
used), the OS will not start up, if such mirroring configuration is performed after the OS is installed to
the attached CF. Therefore, make sure to add another CF when building mirroring. For more details,
refer to "Building a new mirroring (RAID 1) using two CFs".

If your problem cannot be resolved

Contact your retailer.
21
PC-RSD Series