Contec IPC Series User Manual page 43

4. About the RAID Building Software
(3) Setup the following setting items.
You can move to each item with the [↑][↓] key, and change each setting value with the [Space] key.
Once you have changed these settings, press [Ctrl-Y] (while hoiding down [Ctrl], press the [Y]
key).
Setting item
Array Mode
Drive Assignment
IT8212 Setup Utility (C) Copyright 2002 - 2004 ITE, Inc.
Array No.
Array 0
Block Size
Channel
ID Drive Name
Pri/D0 SanDisk SDCFH - 1024
Sec/D0 SanDisk SDCFH - 1024
* : Capacity (GB)
[↑] Up [↓] Down
(4) Press [Y] key to set spanning. The data of the selected CF will be erased upon selecting spanning
for the CF by pressing [Y] key and the data cannot be restored.
Erase old data in this new array?
Y - Yes / N - No
CAUTION
- The data of the CF will be erased upon pressing [Y] key and the data cannot be restored.
- When [N] is pressed, the partition information for the CF and other data will not be erased, but
since the spanning information is being set, they cannot be restored. However, they can be
restored if RAID is cancelled before any formatting or writing is made on the CF. For instructions
on how to cancel RADI, see "Chapter 4 Canceling RAID Setting". If the following message is
displayed while canceling RAID, press [N] key.
Erase the data in the array?
Y - Yes / N - No
(5) Press [Esc] key to return to [Define RAID Menu].
38
Span
[Y] : Spanning is set
[N] : Spanning is not set
[Define RAID Sub-Menu]
Array Mode Drive No.
Span
Not available
[Drive Assignments]
[Space] Change Option
Setting value
Change the setting
for each item using
[Space] key.
(1) Select [Span].
0
Size (MB)
977
977
[Ctrl-Y] Save
Status
Non-functional
(2) Set to [Y].
Assignment
Y
Y
[ESC] Exit
PC-RSD Series