Omron CJ1G/H-CPU series Operation Manual page 235

Examples
6. PLC Setup Settings
202
Specify holding or clearing
CPU Bus Unit information.
These settings are the CPU Unit's software configuration.
The PLC Setup settings are arranged by word addresses when a Program-
ming Console is used to make PLC Setup settings. This example shows a
Programming Console used to make the following settings:
• Set a Minimum Cycle Time in 1-ms units.
• Set a Watch Cycle Time (maximum cycle time) in 10-ms units.
Address
208 0 to 15
209 15
0 to 14
Note When a host computer or PT is connected to the peripheral port or RS-232C
port, the port must be set for Host Link or NT Link communications in the PLC
Setup. When a standard serial device is connected, the port must be set for
no-protocol communications in the PLC Setup.
Specifying a word address in the PLC Setup.
(Example: 209)
2
↓
000000 I/O TBL
WRIT OK
000000 CT00
CLR
Setting with a Programming Console
Bits
Minimum cycle time setting
Enable for Watch Cycle Time
setting
Watch Cycle Time setting
000000 CT00
CLR
PC SETUP
FUN VRFY
0:MODE1:PC SETUP
PC SETUP
1
+000 0000
PC SETUP
0 9
+209
PC SETUP
↑
+209
or
PC SETUP?
CHG
+209
Section 4-2
Setting Setting range
0001 to 7D00
0: Use default
1: Use setting in
bits 0 to 14.
0001 to 0FA0
0000
0000 0000