Table of Contents
Advertisement
Func.
Name
Code
a058
DC braking time at start
Carrier frequency during DC
a059
braking
A061
Frequency upper limit
Frequency upper limit,
A261
2nd motor
A062
Frequency lower limit
Frequency lower limit,
A262
2nd motor
A063
A065
Jump freq. (center) 1 to 3
A067
A064
Jump freq. width (hysteresis) 1
A066
to 3
A068
A069
Acceleration hold frequency
A070
Acceleration hold time
A071
PID enable
"A" Function
Description
Sets the duration for DC braking,
range is from 0.0 to 60.0
seconds
Carrier frequency of DC braking
performance, range is from 2.0 to
15.0kHz
Sets a limit on output frequency
less than the maximum
frequency (A004).
Range is from frequency lower
limit (A062) to maximum
frequency (A004).
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output frequency
less than the maximum
frequency (A204).
Range is from frequency lower
limit (A262) to maximum
frequency (A204).
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output frequency
greater than zero.
Range is start frequency (B082)
to frequency upper limit (A061)
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output frequency
greater than zero.
Range is start frequency (B082)
to frequency upper limit (A261)
0.0 setting is disabled
>0.0 setting is enabled
Up to 3 output frequencies can
be defined for the output to jump
past to avoid motor resonances
(center frequency)
Range is 0.0 to 400.0 Hz
Defines the distance from the
center frequency at which the
jump around occurs
Range is 0.0 to 10.0 Hz
Sets the frequency to hold
acceleration, range is 0.0
to 400.0Hz
Sets the duration of acceleration
hold, range is 0.0 to 60.0
seconds
Enables PID function,
three option codes:
00...PID Disable
01...PID Enable
02...PID Enable with reverse
output
46
Run
Defaults
Mode
Initial data
Units
Edit
0.0
sec.
5.0
sec.
0.00
0.00
0.00
0.00
0.0
0.0
0.0
0.5
0.5
0.5
0.00
0.0
sec.
00
Hz
Hz
Hz
Hz
Hz
Hz
Hz
−
Advertisement
Table of Contents
