Hitachi WJ200-004M Quick Reference Manual page 14

[Setting example]
After power ON, changing from 0.00 display to change the b083 (carrier frequency) data.
Press [ESC] key to show
the function code
d001
ESC
Press [ESC] key to move
on to the function group
F001
ESC
Press [ESC] key twice to move
on to the function group b001.
b001
function code
b083
Press up key to increase the
data (5.0
:Fix and stores the data and moves back to the function code
SET
:Cancels the change and moves back to the function code
ESC
Function code dxxx are for monitor and not possible to change.
Function codes Fxxx other than F004 are reflected on the performance just after changing the data
(before pressing SET key), and there will be no blinking.
When a function code is shown...
ESC key Move on to the next function group
SET key Move on to the data display
key Increase function code
key Decrease function code
Note
Keep pressing for more than 1 second leads to d001 display, regardless the display situation. But note that
the display will circulates while keep pressing the [ESC] key because of the original function of the key.
(e.g. F001 A001 b001
ESC
SET
F001
Press Up key to change increase
(b001 b083)
Press SET key to display the data of
SET
ESC
12.0)
SET
Press SET key to set
and save the data
C001 ... displays 50.00 after 1 second)
Data of d001 will be shown on the
display after the first power ON
0.00
b083
Display is lit solidy
5 0
.
When data is changed, the display
12 0
.
starts blinking, which means that new
data has not been activated yet.
When data is shown...
Cancels the change and moves back to the
function code
Fix and stores the data and moves back to
the function code
Increase data value
Decrease data value
13