Motors With Drive-Cliq - Siemens 1FT6031-4AK71-4AH0-Z Manual

Motor Components (Options)

4.3 Motors with DRIVE-CLiQ

4.3 Motors with DRIVE-CLiQ
Motors with DRIVE-CLiQ have a sensor module that includes the encoder evaluation, the
motor temperature sensing and an electronic rating plate.
This sensor module instead of the signal connector and has a 10-pin RJ45-plus socket.
Caution
The sensor module contains motor and encoder-specific data as well as an electronic rating
plate. This is the reason that this sensor module may only be operated on the original motor
- and may not be mounted onto other motors or replaced by a sensor module from other
motors.
The sensor module has direct contact to components that can be destroyed by electrostatic
discharge (ESDS). Neither hands nor tools that could be electrostatically charged may come
into contact with the connections.
Cables
For all encoder types (incremental encoder, absolute value encoder, resolver), the same
DRIVE-CLiQ cable is used.
The following cable should be used to connect an encoder:
Table 4-3
6FX ☐ 002 - ☐DC☐☐ - ☐☐☐ 0
Only prefabricated cables from Siemens (MOTION-CONNECT) may be used.
Additional technical data and length code, refer to Catalog, Chapter "MOTION-CONNECT
connection system"
4-4
Prefabricated cable
↓ ↓↓↓
↓ Length
5 MOTION- Max. cable length 100 m
CONNECTⓇ500
8 MOTION- Max. cable length 50 m
CONNECTⓇ800
Configuration Manual, (PFT6), Edition 12.2004, 6SN1197-0AD12-0BP0
1FT6 synchronous motors