Siemens 1FT6031-4AK71-4AH0-Z Manual page 12

Foreword
Caution
The motors can have surface temperatures of over +100° C.
This is the reason that temperature-sensitive components, e.g. cables or electronic
components may neither be in contact nor be attached to the motor.
When connecting-up cables, please observe that they
– are not damaged
– are not subject to tensile stress
– cannot be touched by rotating components.
Caution
The DRIVE-CLiQ interface contains motor and encoder-specific data as well as an electronic
rating plate. This is the reason that this Sensor Module may only be operated on the original
motor - and may not be mounted onto other motors or replaced by a sensor module from
other motors.
The DRIVE-CLiQ interface has direct contact to components that can be
damaged/destroyed by electrostatic discharge (ESDS). Neither hands nor tools that could be
electrostatically charged may come into contact with the connections.
Caution
SINAMICS drive units with synchronous motors are subject, as part of the routine test, to a
voltage test in accordance with EN 50178. While the electrical equipment of industrial
machines is being subject to a voltage test in accordance with EN60204-1, Section 19.4, all
SINAMICS drive unit connections must be disconnected/withdrawn in order to avoid
damaging the SINAMICS drive units.
Motors should be connected-up according to the circuit diagram provided. It is not
permissible to directly connect the motors to the three-phase line supply. Motors will be
destroyed if they are connected directly to the three-phase line supply.
Note
SINAMICS units with synchronous motors fulfill, when operational and in dry operating
rooms, the Low-Voltage Directive 73/23/EEC.
SINAMICS units with synchronous motors fulfill, in the configuration specified in the
associated EC Declaration of Conformity, the EMC Directive 89/336/EEC.
vi
Configuration Manual, (PFT6), Edition 12.2004, 6SN1197-0AD12-0BP0
1FT6 synchronous motors