Relationship Between Unit Versions Of Units; Version Information With Communications Coupler Units; A-6-1 Connection To An Ethercat Coupler Unit - Omron NX-ILM400 User Manual

Appendices
A-6 Version Information with Communica-
tions Coupler Units
This section provides version-related information when connecting Units to a Communications Coupler
Unit.
Version information is provided separately for each Communications Coupler Unit that an NX Unit is
connected to.
A-6-1 Connection to an EtherCAT Coupler Unit
This section describes the relationship between the unit versions of each Unit, EtherCAT Coupler Unit,
CPU Unit and Industrial PC, versions of the Sysmac Studio and CX-ConfiguratorFDT, and the specifica-
tion changes for each unit version.

Relationship between Unit Versions of Units

NX Unit
Model
Model numbers
of NX Units.
The version combination table is given below.
• With the combinations of the unit versions/versions shown below, you can use the functions that are
supported by the unit version of the Unit model. Use the unit versions/versions (or the later/higher
unit versions/versions) that correspond to the NX Unit models and the unit versions. You cannot use
the specifications that were added or changed for the relevant NX Unit models and the unit versions
unless you use the corresponding unit versions/versions.
• Depending on the type and model of the Unit to which the NX Unit is connected, some Units do not
have the corresponding versions given in the table. If a Unit does not have the specified version, sup-
port is provided by the oldest available version after the specified version. Refer to the user's manu-
als for the specific Units for the relation between models and versions.
• If you use the corresponding unit versions/versions given in the following table or later/higher ver-
sions, refer to the version information in the user's manual for the Communications Coupler Unit,
CPU Unit, and Industrial PC.
Model
NX-ILM400
A - 38
EtherCAT Cou-
Unit version
pler Unit
Unit versions of Unit versions of
NX Units. EtherCAT Cou-
pler Units that
are compatible
with the NX
Units.
NX Unit
EtherCAT Cou-
Unit version
pler Unit
Ver.1.0 Ver.1.0
Ver.1.1
Corresponding unit version/version
CPU Unit or
Sysmac Studio
Industrial PC
Unit versions of Sysmac Studio
NJ/NX-series versions that
CPU Units or are compatible
NY-series with the NX
Industrial PCs Units, Ether-
that are compat- CAT Coupler
Units, CPU
ible with the Eth-
erCAT Coupler Units, and
Units. Industrial PCs.
Corresponding unit version/version
CPU Unit or
Sysmac Studio
Industrial PC
Ver.1.12 Ver.1.16
Ver.1.20
NX-series IO-Link Master Unit User's Manual (W567)
CX-Configura-
torFDT
The version of
the CX-Configu-
rat orFDT that
supports the
IO-Link Master
Unit.
CX-Configura-
torFDT
Ver.2.2