Checking For Errors And Troubleshooting On The Support Software; Checking For Errors From The Sysmac Studio - Omron NX-ILM400 User Manual

7 Troubleshooting
7-3 Checking for Errors and Trouble-
shooting on the Support Software
Error management on the NX Series is based on the methods used for the NJ/NX-series Controllers.
This allows you to use the Support Software to check the meanings of errors and troubleshooting pro-
cedures. The confirmation method depends on the Support Software.
7-3-1

Checking for Errors from the Sysmac Studio

When an error occurs, you can place the Sysmac Studio online to the Controller or the Communications
Coupler Unit to check current Controller errors and the log of past Controller errors.
Refer to the user's manual for the connected CPU Unit or Communications Coupler Unit for information
on checking errors.
Current Errors
Open the Sysmac Studio's Controller Error Tab Page to check the current error's level, source,
source details, event name, event codes, details, attached information 1 to 4, and correction.
Errors in the observation level are not displayed.
Additional Information
Number of Current Errors
The following table gives the number of errors that are reported simultaneously as current
errors in each Unit.
NX-ILM400
If the number of errors exceeds the maximum number of reportable current errors, errors are
reported with a priority given to the oldest and highest-level errors. Errors that exceed the limit
on simultaneous error notifications are not reported.
Errors that are not reported are still reflected in the error status.
7 - 4
Unit
15 errors
Number of simultaneous error notifications
NX-series IO-Link Master Unit User's Manual (W567)