Checking For Errors From Support Software Other Than The Sysmac Studio; Event Codes And Corrections For Errors - Omron NX-ILM400 User Manual

Log of Past Errors
Open the Sysmac Studio's Controller Event Log Tab Page to check the times, levels, sources, source
details, event names, event codes, details, attached information 1 to 4, and corrections for previous
errors.
Additional Information
Number of Logs of Past Errors
Each event log can contain the following number of records.
The oldest events are overwritten if there are more than 15 events in the system event log or
two events in the access event log.
Refer to the NJ/NX-series Troubleshooting Manual (Cat. No. W503) and the Sysmac Studio Version 1
Operation Manual (Cat. No. W504) for the items that you can check and the procedures to check for
errors.
Refer to 7-3-3 Event Codes and Corrections for Errors on page 7-5 for details on event codes.
7-3-2 Checking for Errors from Support Software Other Than the
Sysmac Studio
You can check the error descriptions and logs with Support Software other than the Sysmac Studio. For
the error checking methods, refer to the user's manual for the connected Communications Coupler Unit
and the operation manual for the Support Software.
Refer to 7-3-3 Event Codes and Corrections for Errors on page 7-5 for details on event codes.
The number of current errors and the number of error log errors that occurred in the past are the same
as for the Sysmac Studio.
7-3-3

Event Codes and Corrections for Errors

Refer to the IO-Link System User's Manual (Cat. No. W570) for a list of the errors (events) that can
occur in an IO-Link Master Unit.
NX-series IO-Link Master Unit User's Manual (W567)
7 Troubleshooting
7 - 5
7