Omron NX-ILM400 User Manual page 165

Functions That Were Added or Changed for Each Unit Version
The following table shows the relationships between the unit versions/versions of the NX Units, Com-
munications Coupler Units, CPU Units, Industrial PCs, Sysmac Studio, and CX-ConfiguratorFDT for
changes in or additions to the functions.
The items that are used in the version corresponding table for functions are given below.
Change or
Function
addition
Func- Indicates
tions of whether the
NX Units. function was
newly added
or changed.
The version corresponding table for functions is as follows.
• You can also use the added or changed functions with the unit versions/versions given in the table or
with later/higher versions.
• Depending on the type and model of the Unit to which the NX Unit is connected, some Units do not
have the corresponding versions given in the table. If a Unit does not have the specified version, sup-
port is provided by the oldest available version after the specified version. Refer to the user's manu-
als for the specific Units for the relation between models and versions.
• If you use the corresponding unit versions/versions given in the following table or later/higher ver-
sions, refer to the version information in the user's manual for the Communications Coupler Unit,
CPU Unit, and Industrial PC.
Change
Function or addi-
tion
Initial I/O alloca- Change
*1
tion value
Digital input col- Addition NX-ILM400
lection
Addition of NX Addition NX-ILM400
*2
objects
*1. The following I/O allocations are enabled by default.
Digital Input Data
Digital Output Data
*2. The following objects are added.
Vendor Name of the Last Connected IO-Link Device
Product Name of the Last Connected IO-Link Device
Vendor Name
Product Name
NX-series IO-Link Master Unit User's Manual (W567)
NX Unit
Model Unit version
Coupler Unit
Unit versions
Model Unit versions
num- of the NX of EtherCAT
bers of Units that are Coupler Units
NX compatible that are com-
Units. with the func- patible with the
tion. NX Units with
the function.
NX Unit
Model Unit version
NX-ILM400 Ver.1.1
Ver.1.1
Ver.1.1
Corresponding unit version/version
EtherCAT CPU Unit or
Industrial PC
Unit versions
of the
NJ/NX-series
CPU Units or
NY-series
Industrial PCs
that support
the Ether- CAT
Coupler Units.
Corresponding unit version/version
EtherCAT CPU Unit or
Coupler Industrial
Unit PC
Ver.1.0 Ver.1.12
Ver.1.0 Ver.1.12
Ver.1.0 Ver.1.12
Appendices
Sysmac Stu- CX-Configura-
dio torFDT
Sysmac Stu- The version of
dio versions the CX-Config-
that are com- uratorFDT that
patible with the supports the
NX Units, Eth- IO-Link Master
erCAT Cou- Unit.
pler Units and
CPU Units.
Sysmac CX-Config-
Studio uratorFDT
Ver.1.20 Ver.2.2
Ver.1.20 Ver.2.2
Ver.1.20 Ver.2.2
A - 39
A