Configuring Global Bridge Settings - Planet Networking & Communication WGS3-2620 User Manual

4.5.3.1 Configuring Global Bridge Settings

The following figure and table describe bridge configuration for STA, GMRP, GVRP, priority threshold,
and address aging time.
Parameter Default
Spanning Tree Enabled
Bridge Priority 32,768
Hello Time 2
WGS3 Layer 3 Switch User's Manual
Description
Enable this parameter to participate in a STA compliant network.
Bridge priority is used in selecting the root device, root port, and
designated port. The device with the highest priority becomes the STA
root device. However, if all devices have the same priority, the device
with the lowest MAC address will then become the root device.
Enter a value from 0 - 65535.
Remember that the lower the numeric value, the higher the priority.
Time interval (in seconds) at which the root device transmits a
configuration message.
The minimum value is 1.
The maximum value is the lower of 10 or
[(Max. Message Age / 2) -1].
- 47 -