Ospf Area Configuration - Planet Networking & Communication WGS3-2620 User Manual

5.7.5.2.3.1 OSPF Area Configuration

OSPF protocol broadcast messages (i.e., Link State Advertisements) are restricted by area to limit their
impact on network performance. Before assigning an Area ID to a specific OSPF interface, you must first
specify the Area ID in this table. Each entry in this table identifies a logical group of OSPF routers that
actively exchange Link State Advertisements (LSAs) to ensure that they share an identical view of the
network topology. You can configure the area as a normal one which can send and receive external Link
State Advertisements (LSAs), a stubby area that cannot send or receive external LSAs, or a
not-so-stubby area (NSSA) that can import external route information into its area.
Parameter
Area ID
Type
An Autonomous System Boundary Router (ASBR) can import external routes and flood this information
to the entire Autonomous System.
WGS3 Layer 3 Switch User's Manual
Description
An OSPF area identifier configured for a group of OSPF routers. (For information
on how to assign this identifier to a specific interface, see4.5.6.1.5 Configuring
OSPF.)
Indicates area type:
Normal – An area which can send or receive external route information.
Stub – An area which cannot send or receive external route information. It relies
on a single default route provided by its Area Border Router (ABR) to access
destinations outside of the stub. A stub can be used to reduce the amount of
topology data that has to be exchanged over the network.
NSSA – A not so stubby area cannot send but can receive external route
information. The ABR imports external routes and floods this information to all
routers within the NSSA.
- 189 -