Changing The Network Configuration - Planet Networking & Communication WGS3-2620 User Manual

4.4.1 Changing the Network Configuration

Use the Network Configuration menu to set the bootup option, configure the switch' s Internet Protocol
(IP) parameters, or enable the on-board Web agent. The screen shown below is described in the
following table.
Parameter
IP Configuration*
IP Connectivity Test (Ping)
HTTP Configuration
* This menu does not appear on WGS3-404 or if the WGS3-2620 is set to multilayer mode. In this case,
you need to configure an IP interface for each VLAN that needs to connect to any device outside of its
own VLAN group. (See "Subnet Configuration")
WGS3 Layer 3 Switch User's Manual
Description
Screen used to set the bootup option, or configure the switch's IP
parameters.
Screen used to test IP connectivity to a specified device.
Screen used to enable the Web agent.
- 22 -