Static Route Configuration - Planet Networking & Communication WGS3-2620 User Manual

5.7.5.4 Static Route Configuration

This switch can be configured to dynamically learn the routes to other IP networks, subnets or hosts
using unicast or multicast routing protocols. If the route to a specific destination cannot be learned via
these protocols, or you wish to restrict the path used for transmitting traffic to a destination, it can be
statically configured using the Static Route Table.
Before defining a static route, remember that you must first configure at least one IP interface on this
switch(See
WGS3 Layer 3 Switch User's Manual
- 196 -