Module Hardware Description; Panel Description; Wgsw-C1Gt Led Definition - Planet Networking & Communication WGS3-2620 User Manual

Console
Port
Power
Console
NOTE: To depress the Buzzer button will change the reaction of the buzzer. If the button is set to on,
the buzzer will ring as the system is under the status of overheat. Set to off, the buzzer will not
work even if the system overheats.

2.2.4 Module Hardware Description

WGS3-404 provides 4 slots for optional Gigabit copper and fiber module. The following picture show
that front panel of gigabit expansion module.

2.2.4.1 Panel Description

WGSW-C1GT Module Status LEDs

2.2.4.2 WGSW-C1GT LED Definition

LED Color
1000 Green
100 Green
10 Yellow
FDX/COL Yellow
Act Green
WGS3 Layer 3 Switch User's Manual
Function
This is where you will connect the AC power cord. 100~240VAC is allowed.
This is where you will connect to the RS-232 serial port on your PC for
configuring the management function, discussed in Chapter 3.
Function
Lights to indicate that the Switch is sending or receiving data at 1000
Mbps.
Lights to indicate that the Switch is sending or receiving data at 100
Mbps.
Lights to indicate that the Switch is sending or receiving data at 10
Mbps.
Lights green to indicate that the port is operating in full-duplex mode.
Blinks orange periodically to indicate that the connection is experiencing
collisions.
Lights to indicate that the connection is acting.
Buzzer Button
WGSW-C1SX Module Status LEDs
- 7 -
Power