Wgsw-C1Sx Led Definition; Mounting The Switch; Mounting Switches In A Rack; Connecting The Switch System - Planet Networking & Communication WGS3-2620 User Manual

2.2.4.3 WGSW-C1SX LED Definition

LED Color
1000 Green
Act Green
FDX/COL Yellow

2.3 Mounting the Switch

The switch can be placed directly on your desktop, or mounted in a rack. Before you start installing the
switch, make sure you can provide the right operating environment, including power requirements,
sufficient physical space, and proximity to other network devices that are to be connected. Verify the
following installation requirements:
• Power requirements: 100 to 240 V AC (+/-10%) at 50 to 60 Hz (+/-3Hz). The switch's power
supply automatically adjusts to the input voltage level.
• The switch should be located in a cool dry place, with at least 10 cm. (4 in.) of space on the
sides for ventilation.
• Place the switch out of direct sunlight, and away from heat sources or areas with a high amount
of electromagnetic interference.
• If you intend to mount the switch in a rack, make sure you have all the necessary mounting
screws, brackets, bolts and nuts, and the right tools.
• Check if network cables and connectors needed for installation are available.

2.3.1 Mounting Switches in a Rack

Please comply with the following instructions to ensure that your switch is securely mounted in the rack.
• Use a standard EIA 19-inch rack.
• Use the brackets and screws supplied in the rack mounting kit.
• Use a cross-head screwdriver to attach the brackets to the side of the switch.
• Position the switch in the rack by lining up the holes in the brackets with the appropriate holes on
the rack, and then use the supplied screws to mount the switch in the rack.

2.4 Connecting the Switch System

The transmission speed for each port on the switch is automatically set by the switch to match the
highest speed supported by the connected device. The transmission mode can be set for each port using
auto-negotiation (if also supported by the attached device). However, if the device attached to any port
on the switch does not support auto-negotiation, you can manually configure the transmission mode via
the console port on the rear panel, or via an in-band connection (including Telnet, the Web agent).
WGS3 Layer 3 Switch User's Manual
Function
Lights to indicate that receiver of fibre port is in normal optical input
levels.
Lights to indicate that the connection is acting.
Lights to indicate that the port is operating at full duplex. This port does
not support half duplex.
- 8 -