Table of Contents
Advertisement
Before installing the switch, verify that you have all the items listed under "Package Contents." Also be
sure you have all the necessary tools and cabling before installing the switch. Note that this switch can
be installed on any suitably large flat surface or in a standard EIA 19-inch rack. After installing the switch,
refer to the following chapter to set up its more advanced features, such as Spanning Tree Protocol or
VLAN port groups.
2.1 Package Contents
This package includes:
• WGS3-404 or WGS3-2620
• Quick Installation Guide
• Rack mount bracket kit
• AC power cord
• This Manual CD
• Console cable
2.2 Description of Hardware
2.2.1 Front Panel of WGS3-2620
The front panel of the Switch has 24 RJ-45 ports for 10/100 Mbps in the middle. The port status LEDs
are indicated at the left. The 1000Base-T ports are situated at the right.
2.2.1.1 Front Panel Description
LEDs
System LEDs
2.2.1.2 Port Description
Ports
# of Ports
10/100
24
1000Base-T
2
WGS3 Layer 3 Switch User's Manual
Chapter 2. Installing the Switch
10/100 RJ-45 Ports
Description
These RJ-45 ports support network speeds of either 10Mbps or 100
Mbps, and can operate in half- or full-duplex modes.
These two RJ-45 ports provide 1000Base-T network connection and
can operate on full-duplex modes.
- 4 -
1000Base-T Ports
Advertisement
Table of Contents
