Main Menu - Planet Networking & Communication WGS3-2620 User Manual

5.4 Main Menu

Using the on-board Web agent, you can define system parameters, manage and control the switch, and
all its ports, or monitor network conditions. The interface screen includes the menu tree on the left side
and a list of commands beneath the image of the switch. The following table briefly describes the
selections available from this program.
Menu
System Information Menu
System Information
Switch Information
Management Setup Menu
Network Configuration
*1
Serial Port
Configuration
SNMP Configuration
User Configuration
TFTP Download
Configuration File
Device Control Menu
*3
System Mode
Layer 2 Menu
Bridge Menu
VLAN Menu
IGMP Snooping
*1
Configuration
*2
IP Menu
Security
WGS3 Layer 3 Switch User's Manual
Description
Provides basic system description, including contact information.
Shows hardware/firmware version numbers, power status, and expansion
modules used in the switch.
Includes IP Configuration, Ping facility, and HTTP (Web agent) setup.
Sets communication parameters for the serial port, including baud rate, console
time-out, and screen data refresh interval.
Activates authentication failure traps; and configures community access strings,
and trap managers.
Sets the user names and passwords for system access.
Downloads new version of firmware to update your system (in-band).
Save or restores configuration data based on the specified file.
Sets the switch to operate as a Layer 2 switch or as a multilayer routing switch.
Configures port communication mode, mirror ports, port trunking and static
unicast/multicast address.
Configures GMRP and GVRP for the bridge, and STA for the global bridge or for
specific ports.
Configures VLAN settings for specific ports, and defines the port membership for
VLAN groups.
Configures IGMP multicast filtering.
Configures the subnets for each VLAN group, global configuration for unicast
and multicast protocols, BOOTP/DHCP relay, static ARP table entries, static
routes and the default route.
Restrict access through MAC address or IP address
- 140 -
*2