Table of Contents
Advertisement
Appendix C: Bar Code Settings
Restoring Default Settings
Important: To improve the decode speed and performance, enable (set to 'on') only
Keep in mind that some bar code types are only available when an internal imaging scanner
is installed. All internal scanners can be configured using these dialog boxes. External, non-
decoded scanners are also configured through the Scanner Properties dialog box.
However, external decoded scanners must be configured by scanning special configuration
bar codes. In these cases, the scanner manufacturer provides programming manuals for con-
figuration purposes.
•
For the Symbol LS3408 decoded scanner, refer to the programming guide supplied with
your scanner.
•
For PowerScan
C.1.2
Restoring Default Settings
If you want to restore the factory defaults after making changes, the defaults can be applied
to a selected parameter, sub-tree of parameters, or all scanner parameters.
•
Press and hold the stylus on a symbology (e.g., Code 128) to display a pop up a menu.
•
Choose Default subtree to reset only the parameters in the symbology you selected, or
choose Default all settings to reset all scanner parameters to default settings.
To reset a single parameter to its default setting:
C-6
Psion Teklogix 7545 Hand-Held Computer User Manual
Preliminary Draft 3
those codes that are required by the application.
®
(PSC) decoded scanners, refer to the PowerScan Programming Guide
Advertisement
Chapters
Table of Contents
