Password Entry - AUMA SG 05.1 Operation Instructions Manual

SG 05.1 SG 12.1/SGR 05.1
AC 01.1 Non-Intrusive Modbus RTU
6.4

Password entry

Information
SGR 12.1 Control unit: electronic (MWG)
Group = Status indications
S
Group = Menu (settings)
M
Group D = Diagnostic indications
The active group is displayed in the top right corner of the display.
Change from group S to group
1. Press push button
appears.
Change from group S to group
2. Press push button
(Thereby, group M is skipped.)
Return from group M or group
3. Briefly press C .
Scrolling within a group:
4. Press or .
The triangles in the top left corner of the display indicate which direction of
scrolling (within one group) is possible.
In the menu (group M ), the settings are password protected. To change the
parameters, a password must be entered first. The following default password is set
in the factory: .
0000
After selecting EDIT , the following is displayed:
ENTER PASSWORD
0 * * *
:EDIT :OK
Step by step:
1.
Select figures 0 to 9: Press
2. Move to the next position: Press
3. Repeat steps 1 and 2 for all four digits.
4. To cancel a process: Press C.
If no input is received over a longer period of time (approx. 10 min.), the controls
automatically return to status indication
M :
C and hold it down for approx. 3 seconds until group
D :
C and hold it down until group
D to group S :
C:ESC
.
.
S0 .
Operation
M0
D0 is displayed.
29