Crankcase Rh - Royal Enfield Classic 500 2009 Service Manual

Engine Dismantling, Inspection & Assembly
✰
Assemble 6305 - C3 bearing after 1st
circlip. Insert 2nd circlip then
bearing spacer in Crank case
LH as shown in Fig.
✰
Assemble NU 305 big roller bearing
after bearing spacer in LH Crank
case for crankshaft.

CRANKCASE RH

✰ Assemble Needle bearing for lay
shaft.
✰
Assemble sleeve gear ball bearing
(6007 R1/C3) and circlip.
NOTE : Ensure the rubber sealed face is
facing the FD sprocket side, while assem-
bling the 6007 bearing.
✰
Insert circlip and then assemble
crankshaft RH side needle roller
bearing into Crank case.
05-38