E- Starter Motor; Rr Unit; Ic Flasher - Royal Enfield Classic 500 2009 Service Manual

Checking Procedure of Electrical Components

E- STARTER MOTOR

✰ ✰ ✰ ✰ ✰ SPECIFICATION
Resistance 0.3 to 0.5 ohms.
✰ ✰ ✰ ✰ ✰ CHECKING PROCEDURE
Set the multimeter in resistance mode.
Check the Resistance between motor ter-
minal & aluminium body.

IC FLASHER

✰ ✰ ✰ ✰ ✰ CHECKING PROCEDURE
Ensure Battery voltage > 12 V, all indica-
tor bulbs are ok. Then starts the vehicle
and turn the indicator switch to LH or
RH mode.
If indicators not functional replace it by a
new IC Flasher.
CAUTION :
Never try to repair / tamper IC Flasher.

RR UNIT

✰ ✰ ✰ ✰ ✰ CHECKING PROCEDURE
Set the multimeter in voltage mode (DCV
20). Connect the multimeter to Battery
terminals and then check the voltage as
shown in Fig.
Start and accelerate upto 3000 RPM and
then check online voltage inbetween 12.2
to 13.5 voltage.
NOTE:
Repeat the test with head light on and
OFF condition. If RR unit is defective will
not fall above specified voltage.
10-9