Hard Drive Connector - HP Sprout Pro Maintenance & Service Manual

Hard drive connector

The hard drive connector is located above the system board.
To remove the hard drive connector:
1. Prepare the computer for disassembly (see
2. Remove the rear covers (see
3. Remove the hard drive (see
4. Remove the memory cover (see
5. Separate the computer from the column (see
6. Remove the system board cover (see
7. Disconnect the hard drive cable from the system board (1).
8. Remove two Torx screws (2) that secure the hard drive connector to the computer.
9. Remove the connector from the computer.
To install the hard drive connector, reverse the removal procedures.
54 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Removing the rear covers from the computer on page
Hard drive on page 26).
Memory on page 29).
Separating the computer from the column on page
System board cover on page
24).
43).
23).
41).