System Board - HP Sprout Pro Maintenance & Service Manual

System board

Before removing the system board, following these steps:
1. Prepare the computer for disassembly (see
2. Remove the rear covers (see
3. Remove the memory cover (see
4. Separate the computer from the column (see
5. Remove the system board cover (see
6. Remove the heat sink (see
7. Remove the fan (see
When replacing the system board, be sure to remove the following components (as needed) from the
defective system board and install on the replacement system board:
● Wireless USB receiver (see
Solid-state drive (see
●
● Memory modules (see
● WLAN/Bluetooth module (see
● Processor (see
Before removing the system board, following these steps:
1. Disconnect all remaining cables from the system board, noting their location for reinstallation as shown
in the following image.
48 Chapter 4 Removal and Replacement Procedures
Removing the rear covers from the computer on page
Memory on page
System board cover on page
Heat sink on page
Fan assembly on page
Wireless USB receiver on page
M.2 cover and solid-state drive on page
Memory on page
WLAN module on page
Processor on page 46)
Preparing to disassemble the computer on page
29).
Separating the computer from the column on page
45).
47).
31)
33)
29)
44)
24).
43).
23).
41).