Hard Drive Connector - HP ZBook Studio G5 Maintenance And Service Manual

Hard drive connector

Description
Hard drive connector
Before removing the hard drive connector, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
Remove the hard drive connector:
1. Disconnect the cable from the system board ZIF connector (1).
2. Remove the two Phillips M2.0×4.0 screws (2) that secure the connector to the computer.
3. Remove the connector from the computer (3).
Reverse this procedure to install the hard drive connector.
48 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page 35).
Hard drive/solid-state drive (2.5 inch) on page
33).
42).
Spare part number
L28668-001 (Cable Kit)