M.2 Cover And Solid-State Drive - HP Sprout Pro Maintenance & Service Manual

M.2 cover and solid-state drive

The location of the M.2 cover is shown in the following image. You do not have to remove the computer from
the column to replace the M.2 solid-state drive.
To remove the M.2 cover and solid-state drive:
1. Prepare the computer for disassembly (see
2. Remove the left rear cover (see
3. Remove the Torx screw from the M.2 cover (1), and then lift the cover off the computer (2).
4. Remove the Phillips M2.0×3.0 screw (1) that secures the solid-state drive to the system board.
Preparing to disassemble the computer on page
Removing the rear covers from the computer on page
23).
24).
M.2 cover and solid-state drive 33