Table of Contents
Advertisement
NOTE:
The password jumper is blue so that it can be easily identified. For assistance locating the
password jumper and other system board components, see the system board components image at
System board callouts on page
5.
Remove the jumper from pins 4 and 6.
6.
Place the jumper on pins 2 or 4.
7.
Replace the memory cover and rear cover and reconnect the external equipment.
8.
Plug in the computer and turn on power. Allow the operating system to start. This clears the current
passwords and disables the password features.
9.
Shut down the computer, unplug the power, and disconnect the external equipment.
10.
Remove the rear cover.
11.
Place the jumper back on pins 4 and 6.
12.
Replace the rear cover.
13.
Reconnect the external equipment, plug in the computer and turn on power.
NOTE:
You will receive POST error messages after clearing CMOS and rebooting advising you that
configuration changes have occurred. Use Computer Setup to reset any special system setups along with
the date and time.
For instructions on Computer Setup, see
51.
Computer Setup (F10) Utility on page
65.
Clearing and resetting the CMOS 105
Advertisement
Table of Contents
