Main Frame And Display - HP Sprout Pro Maintenance & Service Manual

Main frame and display

You can separate the display from the frame while leaving most components installed. You must disconnect
several cables.
To remove the main frame:
1. Prepare the computer for disassembly (see
2. Remove the rear covers (see
3. Remove the memory cover (see
4. Separate the computer from the column (see
5. Remove the system board cover (see
6. Remove the outer plastic trim (see
7. Remove the 17 Torx screws that secure the main frame to the display.
8. Disconnect the following cables:
● LVDS1
TP_USB (display)
●
WCAM
●
● RECEIVER
● P85 (card reader board)
Preparing to disassemble the computer on page
Removing the rear covers from the computer on page
Memory on page 29).
Separating the computer from the column on page
System board cover on page
Outer plastic trim on page
24).
43).
55).
Main frame and display
23).
41).
57